Im not certain this building has 3 phase power. This building was built somewhere in the 30s or 40s.
I can't seem to find my SignalLinc, and ir appears they MIGHT not make it anymore.
I did however find a leviton phase coupler, and a zwave phase coupler. Will any phase coupler work?
Is there any sort of Walkthrough on how to install the SignalLinc? I have an electrician looking at it, but the Instructions that came with it are a little unclear, and they no longer sell it at Smarthome...
I am a long time insteon user at HOME.... I bought this ISY and devices for my work location. So I am a brand new user here. It is an older building.. so Im unsure of the Power legs or the 4 tap test, or anything like that. Where can I read up on that?
Would adding a SignalLinc help? I have a SignalLinc that I bought for my house years ago and never installed because it turned out I didnt need it.
I have been able to add Various Devices by moving the PLM to various Sockets around my location. If Im plugged in NEAR the Insteon Device, it will add it no problem. Once I move it, I can add an insteon device in the new location, but I lose connection to the Old devices...
Do I HAVE to use the cords that came with the ISY, or will any standard Ethernet cable work to connect both the PLM to the ISY and the ISY to the router?
I just unboxed my ISY994i and hooked it up to the network. Plugged in the PLM and connected it.
I can't seem to add ANY of my Insteon devices. I click the Link icon, then press the button on the Device.. and it just goes up to 100% and wont find it. If I click the Lightbulb icon and add it by address,it goes to "adding" then "initializing system" then says the device cannot be found. Cannot determine insteon engine.
Please advise.