Bigm

Hi. On my side, I can confirm it is back to normal and steady state including msg that I program.

Ok. As a last chance ressource, I opened a case with UD. Michel provide me with this procedure:https://wiki.universal-devices.com/index.php?title=INSTEON_No_Status_Feedback_From_Devices Even if the count was more than 0 and less than 900, I restore PLM for 2 of my leak sensors (those on my work bench at the moment). It seems to have fix the problem....for the time being... the other source of problem given by Michel was a signal/noise problem.

Hi lilyoyo1. I just upgraded in case it could solve my problem... it didn't...

Hi f.demello. Ok. This means the problem is not the sensors but something else (moreover, when I wet the contact, I see the green light flashing which means the sensor is doing its job)...so the problem is with isy or within isy...hum... why just the leak sensors....?

Are you telling that even buying a new leak sensor did not solve your problem or you are thinking of buying new sensors?

Hi markv58. As I mentionned, I tried to replace the batteries. No success... at least, for me

Hi. All my water leak sensors (5 of them) stopped working at the same time and control 2 for all of them is not staying in "run then" config. I tried all of the above (change batteries, delete and add back, hard reset). Nothing seems to do it, they do not report any wet condition any more (some are in the basement, main floor and 2nd floor. They have been working for a few years now and suddenly, none are working. I fall short of any solution. Anyone could help, please.

Hi guys. ... seems to be working now... at least for me...

@tmenear I got the same result as you. I hope it is linked to the titled updates and not mine...

Hi. I have the same problem. On version 5.0.15A