Jump to content

Codra

Members
  • Posts

    3
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Codra's Achievements

Newbie

Newbie (1/6)

4

Reputation

  1. It was a custom pcb from an old project but a max3232 chip breakout board would be good enough.
  2. 2245. It is easy to figure out where to connect the serial just by looking at the 18f25j10 datasheet for the tx/rx pins. I'm not sure I want to do a how-to because it does have a single pcb with line voltages on it. But all I did was connect tx,rx,3.3v,gnd and held the pic32 in reset.
  3. Hey everyone. My PLM died recently but I had an insteon hub lying around and so I thought "a hub probably just has a plm inside". I also conveniently had an extra PCB lying around that had space for an rj45 port and rs232 chip. Long story short, it does and it works with a few modifications to connect it to ISY. Just in case you were wondering.
×
×
  • Create New...