DRousseau
Members
-
Joined
-
Last visited
-
Thanks paulbates for your suggestions. Unfortunately, it did not work. So I did a factory reset on the PLM, replug on the eisy and then the PLM shows as connected. Then, I restored the PLM and everything works fine now.
-
And on top of all issues, the system is endlessly busy and the devices are in the writing state. Any help would be appreciated. Or a link to guide me to start over the migration again.
-
It seems that the PLM does not work properly. It shows as not connected even though it is connected. This is a brand new PLM 2413U. Is there any way to test the PLM ?
-
-
Just migrated yesterday from isy994 to eisy using the isy backup file. Cannot turn off/on lights in the admin console. UD Mobile does not work either. Photos show the errors encountered. Any suggestion ?
-
Hello, Just as an introduction, I bought a house 12 years ago with about 50 Insteon devices already installed. I have changed the controller to an isy994 about 9 years ago. Over time, I have replaced some dead devices and add about 20 more. But I am far from considering myself an expert. Now let's get to the issue. A couple of weeks ago, we had a power outage. I did not notice until 3 days ago that 2 devices (both 2476d) in the basement were dead. Devices that were working since I bought the house. When I unscrewed the devices to replace them, I got the surprise to see that there is only one set of 3-wire electrical cable. So, I did the same connections as they were with brand new 2477d: white-white, black-black and capped the load (red) wire. When I turn it on, the leds works fine but the bulb does not light up ! Both act the same. Anybody has a clue to help me resolve the issue ? Regards.
