CLU

@bigDvette Check the insteon PLM manual. I had the same problem. This worked for me: RJ45 Pin1 --> RS232 RX (2) RJ45 Pin8 --> RS232 TX (3) RJ45 Pin7 --> RS232 GD (5)

I was able to get my PLM to connect. Make sure to double check the manual for 2413S. Some previous posts have the TX/RX reversed This worked for me: RJ45 Pin1 --> RS232 RX (2) RJ45 Pin8 --> RS232 TX (3) RJ45 Pin7 --> RS232 GD (5)

I've had my Windows Phone 7 for a couple of weeks now and was very happy to find this app. This is exactly what I was hoping I could do on my new phone. It's probably the best app I've seen so far on WP7. I use it everyday. Simple, clean and just works - the way I like it. Thank you Ozan! Even my wife, who is a little bit conservative when it comes to new technology now wants it on her phone

Great suggestions. I do have a dimmer. I like the idea of increasing the ramp rate and instead trigger the fast on/on action. I'll try that and using a flag program. Thanks for help!

I would like to delay turning off the light 10 seconds. Is there a way to write a program that trigger the swith before actually turning the light off? This is what I do now but it is annoying to have the light go off and then on again before the delay. If Control "bathroom" is switched off Then set "bathroom" on wait 10 seconds set "bathroom" off any help is appreciated.