drkair

Since I went to Office 2016 my log will not open in excel. It asks if I want to view the log in Excel, I answer yes, Excel opens but no data. Any ideas? DonSR

By looking at the program summary. I just checked the log and the manual pushes do not show up. I don't think I did a factory reset. Drkair

I wanted the same results so I copied Apostolakis' program. If I push the switch "on" the program does not run. if I turn the switch on from the console it works. The same with off. Is my switch defective or am I doing something wrong? I copied it line by line. Drkair

I have (3) dual band units and (5) 2443 access points. I do have an open-close Insteon module I haven't checked. Yes the Triggerlinc had to be relinked. All other Insteon units operated normally, only problem was the wireless units. Is there anything I can do on a mass scale that will put everything back to normal without doing one at a time? Hopefully it will never happen again. Thanks to everyone for the help, Don

All the other Insteon devices worked normally, even the x10 sensors. I ended up deleting and relinking all six of the motion sensors and they seem to be working properly, I will know for sure when it gets a normal dusk dawn cycle. Right now the sensor on-off works. I don't understand how all six motion sensors could do this. Don

Yes but it is not on. So are you thinking I have something in the 915 MHz range that is interfering? I have numerous wireless AP's wireless IP cams throughout the house but they are in the 2.4 GHz range. I am trying to think of something new I added last week. I can bring the sensor to my office and change the options, but even after that it will not show "dusk dawn" or "sensor" just blanks. All of the sensors show "Bat" off. It is not making any sense. Don

All of my sensors just quit working. I can't get any response on my ISY994i. They all worked last week, but I just noticed they quit working. I have (6) sensors and none of them are working. this freaks me out. I have mostly all Insteon motion sensors. I have been adding to them for years. Everything has worked great until this week. I have tried to figure out what is wrong but nothing fits. I still have a few X10 motion sensors and they seem to work. I have brought the sensors up and re synced them but they still don't register movement on the software. I have multiple dual bands through out the house and many 2443's. All of a sudden they just don't show any change on the software. the indicator lights are showing movement. Any ideas? Don