Kid_Icarus

I just printed labels on my laser printer, and affixed them to the Remotelinc 2 unit with tape.

I am experiencing a similar issue and hoping to get some feedback on how to best address. Setup: - My Insteon setup uses the ISY-99i/IR Pro for all communications (i.e. no "device-to-device" control; everything goes through the ISY). - ISY is firmware 3.2.6 Devices: - I have a lamp connected to a LampLinc which works great. - I also have a KeyPadLinc which has button "G" configured in toggle mode to control the LampLinc, and that also works fine. Objective: - My intent is to create a scene on the ISY where both the LampLinc and the "G" key on the KeyPadLinc are controllers. This would ensure that the toggle state (on/off) of the KeyPadLinc button is updated when another device is used to change the state of the LampLinc. Approach: - I created a scene on the ISY. I added both the LampLinc and the "G" button of the KeyPadLinc to the scene. Issue: - My issue is that the ISY interface will only allow me to add the LampLinc as a responder (not as a controller). - I can however add the "G" button of the KeyPadLinc to the scene as a controller. Question: Is it possible to add the LampLinc to the scene as a controller? If so, how?