respecTtheCode

PLM Info/Status: 33.5E.86 v9E / Connected Firmware: v.4.2.22 UI: v.4.2.22 It became unresponsive again this morning. The PLM status showed connected but when I restarted the ISY it booted in Safe Mode. I unplugged the PLM for a few minutes and restarted the PLM. Just like last time the ISY connected to the PLM but couldn't communicate with any of my INSTEON devices. It took 3 factory resets this time to get the PLM restore to work but like last time everything is working after a successful PLM restore.

So the new PLM is became unresponsive over the weekend. Unplugging it wasn't enough to fix it this time. After the first factory reset the restore failed. I tried a second factory reset and restore and it worked. The PLM has been working since. Could anything cause this or did a get a bad PLM? Where can I find information about this UDI PLM?

I had Smarthome replace my PLM and that fixed everything. Thanks for the help.

Good to know. I do have a 2413S that is about a year and a half old. Is there a different PLM that is recommended now?

So that seems to have fixed it. I unplugged both the PLM and the ISY, then plugged in the PLM waited a few minutes and plugged in the ISY.

My ISY has stopped communicating with all of my INSTEON devices. At first it was just 4 or 5 of them but today it has stopped talking to all of them. The INSTEON network is fine and all of my keypad buttons work (except ones that need the ISY). The ISY LEDs don't show any RX or TX traffic now. The admin console loads and is communicating with the ISY fine but most of the devices have red exclamation marks for icons. The few that don't are not controllable from the admin console or web interface. I tried restarting the ISY and even turned off the power to all of my INSTEON devices but nothing seems to help.