Jump to content

hart2hart

Members
 View Profile  See their activity

  • Posts

    1656

  • Joined

  • Last visited

Community Answers

  1. hart2hart
    hart2hart's post in UD Mobile - Pin/FaceID on App Opening was marked as the answer   
    Touch and hold  app icon and it pops up as one of a few options.  
  2. hart2hart
    hart2hart's post in YoLink plugin purchased was marked as the answer   
    Install purchased version in same slot as trial version.
  3. hart2hart
    hart2hart's post in Strange Problem with a Program was marked as the answer   
    The If is evaluated false during that 3 minute wait.
  4. hart2hart
    hart2hart's post in USB Power Cable Question was marked as the answer   
    I did same and bought standard USB to micro USB at Amazon.

    https://www.amazon.com/gp/aw/d/B0C14W14F7?psc=1&ref=ppx_pop_mob_b_asin_image&th=1
  5. hart2hart
    hart2hart's post in Can't restore new PLM was marked as the answer   
    Hi. ISY used serial PLM. You didn’t happen to purchase a USB PLM?
  6. hart2hart
    hart2hart's post in A program call running a disabled program was marked as the answer   
    Yes, you can run if, run then, or run else a disabled program.
  7. hart2hart
    hart2hart's post in If "day of month" = x? was marked as the answer   
    Are there reasons not to use the timedata node server? I use day of month from it as trigger in a few programs.
  8. hart2hart
    hart2hart's post in Every Single Program Disabled Spontaneously was marked as the answer   
    What version are you running? The newest release fixed issues with programs being disabled after an upgrade. Could this have impacted you at another time?
  9. hart2hart
    hart2hart's post in ISY backup fails was marked as the answer   
    Could this mean the SD card has gone bad and you should replace it before doing the restore?
  10. hart2hart
    hart2hart's post in Nodes not controlling Fans and Lights today was marked as the answer   
    @Goose66I realized that PLM was not registering the insteon device update so I did a restore PLM and all is working now -- sorry to have bothered you with it.  Of course the PLM may need a replacement soon.  I'll watch it.  I prophylactically replaced the capacitators a couple years ago.
  11. hart2hart
    hart2hart's post in Moved all node servers to PG3 - now what? was marked as the answer   
    Are you running all on a Polisy? If so, PG2 will use almost no resources without node servers. Also, it’s been mentioned that pg2 will be removed from Polisy by UD sometime in the future
  12. hart2hart
    hart2hart's post in Going back to INSTEON was marked as the answer   
    Those are probably addresses that existed in that switch. When you add there are question about finding them. If that’s your older switches, I’d factory reset each before linking them. I’d delete that one and add again.
  13. hart2hart
    hart2hart's post in ISY died, need replacement was marked as the answer   
    Maybe SD card was damaged when power supply failed. Replace it and restore a backup might be a possibility. Also, just saw post where a rj45 cable went bad and caused issues.
  14. hart2hart
    hart2hart's post in Toggle the button state of an Insteon 2487S 6-button switch with a program was marked as the answer   
    Add the button to a scene (create scene if needed) and turn the scene on and off.
×
×
  • Create New...