Mike1980

That was easy, thanks Jimbo.

Since MYQ open API is down, I am looking at controlling my garage door through the ELK. I currently have an EISY and I have a few questions. 1. Is it better to write the garage open/close/status program through the ELK rules or the EISY? 2. When I'm in the EISY interface under my ELK controller, I only see Light1 and Task1. I do not see any outputs. Any idea on how to add it here? 3. I'm not looking at reinventing the wheel, has anyone already done this and if so, could you send me a sample program whether it was in ELK or EISY?

So I see a couple people creating new ISY iOS apps. Well, I’m very interested in doing the same. I don’t have the slightest idea of where to begin but I’m sure I can learn and figure it out. I just need a little direction. Any advice on where to get started and how to get any developer information? Thanks guys.

Thank you guys.

I know it's the latest firmware but I will check when I'm home. If my memory serves me correctly, there was responding, and 1-100%. There wasn't status but I'll check again.

I'm using a switch to turn on several switches. Here's the problem, in the if statement, it shows percent on level for my trigger. How do I control it if I don't care what level on %, just anytime the button is turned on?