Using Control Functions in programs

[msoileau]

I'm unable to get any of the Control functions to properly trigger a program. I'm attempting to use a ToggleLinc Dimmer (2466DW). Here is what I'm currently trying:

If
       Control 'H.Room / H.Light' is switched Fast Off

Then
       Set 'H.Room / H.Light' 50%
       Wait  10 minutes 
       Set 'H.Room / H.Light' 25%
       Wait  5 minutes 
       Set 'H.Room / H.Light' Off

Else
  - No Actions - (To add one, press 'Action')

From the Event Viewer, I see the Fast Off notification going to the ToggleLinc, however I never notice my program fire. I've tried just standard On or Off as well as Fast On. Status events seem to work, but I want to capture a Fast Off. Anyone have any suggestions?

 

Thanks!

[LeeG]

Post an event trace at LEVEL 3

[LeeG]

"From the Event Viewer, I see the Fast Off notification going to the ToggleLinc,"

 

This may be the issue. If Control is looking at commands coming "from" the device, not a Fast Off going "to" the device.

[msoileau]

I guess that was the problem. I was too lazy to walk upstairs and across the house so I was trying to test by sending a Fast Off from the ISY. Didn't occur to me that it only worked when initiated at the device itself. Is there any way to capture a remotely activated Fast Off for use in this program, or is my best option to just manually run the "Then" block instead of triggering the Fast Off

[LeeG]

If the objective is to test the Then clause it is easiest to right click the Program name selecting Run Then. There is nothing that will simulate a Fast Off from the device.