tracknut Posted February 1, 2014 Share Posted February 1, 2014 I just installed a KPL6 2334-232 Keypad Dimmer, and find that my ISY99i is calling it a 2334-2 KeypadLinc Dimmer 5 Buttons. Looking around a bit, I get the feeling I need to get a ISY994i to support this device. Is that correct? I was under the mis-impression that I didn't need a new ISY994i unless I wanted some new capabilities, and the 99i could support all the various devices. I have a feeling I was wrong about that, but could someone confirm? Thanks Dave Link to comment
LeeG Posted February 1, 2014 Share Posted February 1, 2014 If you have the expected 5 nodes a 6 button KPL should have it is probably okay. However, there are devices not supported on 3.3.10 and that will only increase with time. Link to comment
tracknut Posted February 1, 2014 Author Share Posted February 1, 2014 After I set it up on the ISY, it only shows as one node in the table, which operates correctly on the light that is hardwired as the load on the switch. I don't see the four A-B-C-D notes to use for scenes. though, which of course were the main reason for the KPL... Link to comment
LeeG Posted February 1, 2014 Share Posted February 1, 2014 That is likely the Dual Band KeypadLinc that was released after 3.3.10 was released. Updating to a 994i would be the next step. Link to comment
tracknut Posted February 1, 2014 Author Share Posted February 1, 2014 Ok, thanks much Lee. Link to comment
Recommended Posts