Jump to content

All On or All Off don't reset PLM

Recommended Posts

Whenever I use the All On or All Off on the 2440 Remotelinc it doesn't seem to register the state change in the PLM and this throws off all the other remotes until a double click resets them for each button address. Is there a way to connect this button in a scene so that it resets all the device PLM state data. All the 2440 buttons are registered in scenes on the PLM as are the buttons on all the other remotes. Using any of the other remotes' buttons does not cause this problem.

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...