mfbrin Posted July 27, 2014 Posted July 27, 2014 I have an Insteon motion sensor linked to a light switch. Even though I am in the room, the light goes off at the appropriate time, and I have to wave my hands to turn the light on. If set properly, should the sensor detect my presence and reset the timeout counter? If yes, then I suspect i need to increase the sensitivity of the sensor...is that right? Thanks.
LeeG Posted July 27, 2014 Posted July 27, 2014 The motion sensor options likely need some adjustment. Sensing mode: checked On Only mode: unchecked Night mode: checked Use a Program to turn the SwitchLinc Off If Control 'motion sensor - Sensor' is switched On Then Wait xx seconds Set 'switchlinc' Off Else The Program turns the switchlinc Off xx seconds after the last motion is sensed. All motions will be detected with these options.
mfbrin Posted July 27, 2014 Author Posted July 27, 2014 Thanks. Will this also turn the lights on when you enter the room?
LeeG Posted July 27, 2014 Posted July 27, 2014 Yes it will, assuming the motion sensor sees the motion.
Recommended Posts