jmed999 Posted September 1, 2014 Share Posted September 1, 2014 I didn't see the wiki instructions in time so I didn't unplug the ISY before running the "Restore PLM". What do I need to do since I ran the restore without unplugging the ISY? Link to comment
Teken Posted September 1, 2014 Share Posted September 1, 2014 Sorry I read your reply a few times and it didn't make any sense to me. Say that again? Encrypted By: Phoenix Security Solutions Link to comment
jmed999 Posted September 1, 2014 Author Share Posted September 1, 2014 I had to replace my PLM with a new one. I plugged the new PLM in and ran "Restore PLM" in the admin console. I found the wiki instruction afterwards... http://wiki.universal-devices.com/index.php?title=ISY-99i/ISY-26_INSTEON:File_Menu#Replace_Modem_.28PLM.29 As you can see the instructions gives a warning about not unplugging the ISY. I didn't follow the instructions since I didn't see them in time so I didn't unplug my ISY like it says to. What do I now need to do to correct any issues this may have caused. Link to comment
Teken Posted September 1, 2014 Share Posted September 1, 2014 I would suggest you do it again to ensure the changes are applied correctly. Encrypted By: Phoenix Security Solutions Link to comment
Brian H Posted September 1, 2014 Share Posted September 1, 2014 I would also say try again. This time power down the PLM and ISY Controller. Then power the PLM back up. Let it stabilize for a short time. Then power up the ISY controller. Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.