smokegrub Posted November 3, 2014 Posted November 3, 2014 I just replaced a 5-button KPL using the procedures in wiki. Following replacement, the Admin Console shut down automatically. I rebooted it and the new KPL buttons had appeared with a green icon adjacent to them. I queried the first button and got red apostrophes adjacent to all the buttons. Each of the former buttons in the device tree (those that existed for the deveice that was replaced) had a green icon as well. I queried one of those and it changed to a red apostrophe. Before proceeding further I seek your help.
LeeG Posted November 3, 2014 Posted November 3, 2014 Are both KPLs still in the device list? Was the new KPL primary node selected with a right click?
smokegrub Posted November 4, 2014 Author Posted November 4, 2014 LeeG: I made a mistake. During the wiring of the new device an adjacent device (one included in some scenes on the device being replaced) lost power. I didn't notice that and the replacement process was badly damaged. I ended up deleting the new device from the device tree, doing a factory reset on it and placing it into the device tree. From there I modified each of the scenes it addressed. After what seemed like far too many "write updates" I reassembled everything. I learned a valuable lesson. Check the status of all devices before you start the replacement process!
Recommended Posts