eyost Posted September 27, 2015 Share Posted September 27, 2015 Hi all, I am receiving the 'Cannot determine Insteon engine' when attempting to add a Smoke Bridge to my ISY. I rebooted the ISY but still no success. Any thoughts? Thanks, Ed Link to comment Share on other sites More sharing options...
LeeG Posted September 27, 2015 Share Posted September 27, 2015 If using New INSTEON Device that is the first command sent to the Smoke Bridge. First make sure the Insteon address is correct, 8&A, 0&D, etc can easily be misread. Move the Smoke Bridge to the PLM circuit and try again. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.