smokegrub Posted April 18, 2016 Posted April 18, 2016 After many, many tries I finally got a TriggerLinc into linking mode. It worked for 3 days then stopped. I tried to put it into linking mode to restore it but I could never get the linking light to flash even when a few inches from dual-band devices and the PLM. I then followed the steps to factory reset it. I deleted it and the two programs that used it, removed the battery and held the set button down as the battery was inserted. The set button light would not come on. I removed and replaced the battery and repeated the reset procedure several times again near dual-band devices and the PLM. Nothing. Any ideas? I have one of these installed at another location and a different ISY. It linked on the first try and is about 40 years away from the nearest dual-band device. I think I must have a defective device here.
Brian H Posted April 18, 2016 Posted April 18, 2016 (edited) Your tests and description of what is happening. Sounds like it may have failed. Edited April 18, 2016 by Brian H
Teken Posted April 18, 2016 Posted April 18, 2016 Just for reference can you indicate what the internal white sticker says for hardware revision and production date along with the ISY firmware.
stusviews Posted April 18, 2016 Posted April 18, 2016 I tried to put it into linking mode to restore it but I could never get the linking light to flash even when a few inches from dual-band devices and the PLM. The linking mode is independent of any responder. There doesn't even need to be a responder at all to put the TriggerLinc into linking mode.
jerlands Posted April 18, 2016 Posted April 18, 2016 After many, many tries I finally got a TriggerLinc into linking mode. It worked for 3 days then stopped. I tried to put it into linking mode to restore it but I could never get the linking light to flash even when a few inches from dual-band devices and the PLM. I then followed the steps to factory reset it. I deleted it and the two programs that used it, removed the battery and held the set button down as the battery was inserted. The set button light would not come on. I removed and replaced the battery and repeated the reset procedure several times again near dual-band devices and the PLM. Nothing. Any ideas? I don't have a triggerlinc but on all my battery operated devices the led lights with momentary press of set button. I would make sure you have good battery, that it's installed correctly and that the contacts are in good shape. As Stu noted. You should be able to take it out in a field, place it into linking mode and see the led blink. Jon...
smokegrub Posted April 19, 2016 Author Posted April 19, 2016 The LED will not blink no matter what I do and despite replacing the battery 3 times. I think the device is dead. Just for reference can you indicate what the internal white sticker says for hardware revision and production date along with the ISY firmware. It is a 0215REV 1.B The ISY is 4.3.26 (both)
smokegrub Posted April 20, 2016 Author Posted April 20, 2016 Smarthome has cross-shipped me a new one.
Recommended Posts