smokegrub Posted November 21, 2016 Share Posted November 21, 2016 I have another of these devices and it linked easily. This one is located within 1 foot of a ToggleLinc which linked first try. I have tried air-gapping the device-didn't link. I then did a factory reset. After the factory reset the device linked but then dropped its connection with the red exclamation point. I have since tried to factory reset the device but it will not reset. I get one short beep and the bottom light on the device turns green but it never produces the long beep. The switch controls the incandescent light but will not link. I think I have a defective device. Thoughts/suggestions? Link to comment
stusviews Posted November 21, 2016 Share Posted November 21, 2016 Having the dimmer in proximity of the ToggleLinc won't help.The 2-wire dimmer is RF only. The ToggleLinc is power line only. The dimmer needs to communicate with a dual-band device. Link to comment
smokegrub Posted November 21, 2016 Author Share Posted November 21, 2016 I will install a plug-in dual band device nearby and see what happens. Link to comment
smokegrub Posted November 21, 2016 Author Share Posted November 21, 2016 Poor research on my part. Thanks, Stu. I placed a dual band plug-in about 10-12 feet from the 2-wire and all is well. I will add these details to my device notes. Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.