ISY 994i/IR Pro (1100)

Firmware Insteon_UD994v4.6.2

 

So I bought 8 Insteon PIR's. 

 

I have 4 X-10 outdoor floods (I have the Insteon inline on/off modules but haven't installed those yet).  One step at a time plus it's harder to get to where the X-10 modules are as it is a Two storey house

 

What I want to do.

 

1)   If ANY of the PIR's is motion triggered, and it is night (aka the Dusk sensor is on).

 

2)   Send X-10 D1, 2, 3 and 4 signals to turn on all the floods.

 

3)   After 1 min and 30 seconds send X-10 off signals to the floods, unless another PIR has sent an on signal which will start the 1 minute and 30 seconds again.

 

 

Thoughts ?

Are you using the Insteon 28422-222 Motion Sensor II?

#2420M   -   Yes, I know.  The older version, but new in a box.

Edited October 4, 20178 yr by sun-sense

In away that could be better.

I have seen reports here that the Motion Sensor II is not supported in V 4.6.2.

Though some have added them as the old model and got some basic functions. Without the new features it has.