sun-sense Posted October 4, 2017 Share Posted October 4, 2017 ISY 994i/IR Pro (1100) Firmware Insteon_UD994v4.6.2 So I bought 8 Insteon PIR's. I have 4 X-10 outdoor floods (I have the Insteon inline on/off modules but haven't installed those yet). One step at a time plus it's harder to get to where the X-10 modules are as it is a Two storey house What I want to do. 1) If ANY of the PIR's is motion triggered, and it is night (aka the Dusk sensor is on). 2) Send X-10 D1, 2, 3 and 4 signals to turn on all the floods. 3) After 1 min and 30 seconds send X-10 off signals to the floods, unless another PIR has sent an on signal which will start the 1 minute and 30 seconds again. Thoughts ? Link to comment
Brian H Posted October 4, 2017 Share Posted October 4, 2017 Are you using the Insteon 28422-222 Motion Sensor II? Link to comment
sun-sense Posted October 4, 2017 Author Share Posted October 4, 2017 #2420M - Yes, I know. The older version, but new in a box. Link to comment
Brian H Posted October 4, 2017 Share Posted October 4, 2017 In away that could be better. I have seen reports here that the Motion Sensor II is not supported in V 4.6.2. Though some have added them as the old model and got some basic functions. Without the new features it has. Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.