NewTech Posted June 2, 2009 Posted June 2, 2009 Is it okay to plug in a 3-pin Lamplinc into a 2-pin electrical outlet using a 3- wire to a 2-wire adapter? Will this cause anything in the 3-pin LampLinc not to function?
Brian H Posted June 2, 2009 Posted June 2, 2009 Unless the newest LampLincs where redone. NO problem. All of mine [yes I peaked] the Green Ground wire goes from the rear male pins to the female output pin and does not even connect to the internal PCB board. If you could connect the adapters ground wire to a grounded screw. Then anything on the LampLincs output that used a ground would have one.
Recommended Posts