jacpot Posted July 20, 2009 Share Posted July 20, 2009 Why my 2420M motion sensor stay always on when i use jumper 4 send on only, and trigger on again only after 1 minute he received the last one Link to comment
Sub-Routine Posted July 20, 2009 Share Posted July 20, 2009 Hello jacpot, If the motion sensor never sends an Off then it will be displayed as On after it sees the first motion. The MS, although it does not send and Off, still waits for the no-motion timeout to complete before it sends another On. The shortest delay you can program the sensor for is 30 seconds. Please see this Wiki page: Linking_a_Motion_Sensor. Rand Why my 2420M motion sensor stay always on when i use jumper 4 send on only, and trigger on again only after 1 minute he received the last one Link to comment
jacpot Posted July 21, 2009 Author Share Posted July 21, 2009 Hello Sub-routine, Thanks for reply If i understand there are no way to know when the MS time out occur when the only on jumper is set. Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.