Jump to content

fanlinc and ungrouping buttons


danncas

Recommended Posts

I just installed a fanlinc  with a 6 button keypad.  Every thing works fine. 4 scenes. I ungrouped 4 of the button.  My question is
WHY SHOULD I HAVE NOT DONE THIS???????????????    I read someplace this is not a good idea
Every thing works fine with out adding all the button to the scenes and adjusting it.

Link to comment
Share on other sites

  • 2 weeks later...
On 12/21/2019 at 10:45 PM, danncas said:

I just installed a fanlinc  with a 6 button keypad.  Every thing works fine. 4 scenes. I ungrouped 4 of the button.  My question is
WHY SHOULD I HAVE NOT DONE THIS???????????????    I read someplace this is not a good idea
Every thing works fine with out adding all the button to the scenes and adjusting it.

The warning that pops up when you try to use button groupings explains why it's a bad idea. For your setup at this point (and possibly forever) you won't have issues. However should something be reset, programs based off status of button etc be used the short comings will show up and cause problems

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.


×
×
  • Create New...