claymo Posted December 4, 2020 Posted December 4, 2020 Under Link Management in version 5.3.0, there is a selection to "Link a Remotelinc 2" with "Switch", "4-Scene Keypad", and "8-Scene Keypad". I cannot find a current wiki that describes how to use these. I have brand new 4 scene and 8 scene remotes and can get them to manually link with devices using the manual link without ISY, but then they do not show up in ISY either. How do you link these using ISY? Searching only finds results from several years ago.
claymo Posted December 4, 2020 Author Posted December 4, 2020 Well, this isn't the first time I have posted a question, then figured it out right afterwards. Use New INSTEON Device under the Link Management menu item and enter the 6 byte address on the back. Then push the set button on the remote and it reads it and creates 4 separate nodes for the 4 scene and 8 for the 8 scene. Go figure! 1
Recommended Posts