Blackbird Posted June 5, 2022 Posted June 5, 2022 (edited) Just bought a new house and I hooked up two existing dsc motion sensors and door sensors to my elk m1 and they seem to be NO because the motion detector is violated when there is no motion and normal when there is and the door is violated when closed. This is shown this way in Agave and on the panel. How do I reverse this? On the sensor it shows that it's connected to normally closed. Thanks Edited June 5, 2022 by Blackbird
Blackbird Posted June 5, 2022 Author Posted June 5, 2022 Ok been a while since I installed the ELK and forgot that you can change the NC/NO status on the panel.
Recommended Posts