Chris Jahn Posted December 30, 2022 Posted December 30, 2022 * IoX = ISY on Anything. Welcome to ZMatter Z-Wave+ Beta ! In this build we focused primarily on migration either from a Z-Wave network using our original implementation on Polisy/Eisy, or from an ISY-994 backup (containing a 500 Series Z-Wave backup). Getting Started Make a backup of Polisy (Admin Console | File | Backup IoX ) Launch the Admin Console, go to the Configuration tab, click on Update Packages. Warning, this might take a while depending on how current your OS is Once completed (4 beeps + 1), unplug Polisy If you are using INSTEON, make sure the PLM is connected Power up your Polisy note that initial boot might take a much longer time than normal because udx might want to install missing packages to assist with migration (in the future) Once boot up is complete, Launch Admin Console Migrating to ZMatter Z-Wave+ Go to the configuration tab and press the Migrate to ZMatter Z-Wave button to start migration Please pay close attention to the instructions Do not unplug or install any Z-Wave boards / dongles until instructed to do so during migration When IoX restarts for the first time during migration, you will see that your old Z-Wave nodes are not enabled. As the device interviews proceed, they will become enabled as they are updated with data from the new Z-Wave implementation. The best way to monitor the progress is to open the Admin Console Event Viewer to level 3 For those who want lots of low-level details, you can also use this from the command line: tail -f /var/isy/FILES/LOG/ZWAY.LOG Note: The only way to go back to the original Z-Wave implementation is to restore a backup that was made prior to moving to ZMatter Z-Wave+ Here are the installation instructions for those of you with a ZMatter Z-Wave board (not USB dongle): ZMatter-Assembly- Instructions.pdf (universal-devices.com). Ensure that the antennas are connected in the proper location (Z-Wave = yellow band, on the left. Zigbee = red band, on the right) Features Migration from existing network (e.g. Zooz) Migration from ISY-994 500 Series Backup Bug Fixes Set/Query Configuration parameters Some sensor values not available (e.g. humidity for multisensor 6) Change default of "Detect Button Press" to OFF Hail not working for some devices (not able to fully test this because we do not have a device with this problem) Next Bug fixes, including better support for detecting events from button presses, motion sensors etc. 1
Recommended Posts