IoX Release v5.5.3 - OUTDATED

* IoX = ISY on Anything.

Welcome to ZMatter Z-Wave+ Beta !

In this build we focused on fixing issues with migration along with a few other bugs.

Additionally, you can now use the "Migrate to ZMatter Z-Wave" button on the configuration tab to take a "migration" backup of Polisy or eisy.  This "migration" backup (different than a regular backup) migrates your Z-Wave network when restored on any Polisy or Eisy.  You only need the Z-Wave dongle containing your Z-Wave network (e.g. Zooz) plugged in when making the backup.

Getting Started

• Make a backup of Polisy (Admin Console | File | Backup IoX )
• Launch the Admin Console, go to the Configuration tab, click on Update Packages. Warning, this might take a while depending on how current your OS is
• Once completed (4 beeps + 1), unplug Polisy
• If you are using INSTEON, make sure the PLM is connected
• Power up your Polisy note that initial boot might take a much longer time than normal because udx might want to install missing packages to assist with migration (in the future)
• Once boot up is complete, Launch Admin Console

Migrating to ZMatter Z-Wave+

• Go to the configuration tab and press the Migrate to ZMatter Z-Wave button to start migration
• Please pay close attention to the instructions
• Do not unplug or install any Z-Wave boards / dongles until instructed to do so during migration
• When IoX restarts for the first time during migration, you will see that your old Z-Wave nodes are not enabled.  As the device interviews proceed, they will become enabled as they are updated with data from the new Z-Wave implementation.
• The best way to monitor the progress is to open the Admin Console Event Viewer to level 3
• For those who want lots of low-level details, you can also use this from the command line: tail -f /var/isy/FILES/LOG/ZWAY.LOG

• Note: The only way to go back to the original Z-Wave implementation is to restore a backup that was made prior to moving to ZMatter Z-Wave+

     Here are the installation instructions for those of you with a ZMatter Z-Wave board (not USB dongle):

• ZMatter-Assembly- Instructions.pdf (universal-devices.com).
•  Ensure that the antennas are connected in the proper location (Z-Wave = yellow band, on the left. Zigbee = red band, on the right)

Features

• Support migration using a "migration" backup of Polisy

Bug Fixes

• Fixed issues with synchronize | New & Deleted with interview
• Some binary sensor values were not available
• Better detection of the Z-Wave dongle / board (i.e. the "Initializing System" bug)
• ISY Nodes not being created for some devices
• System configuration being reset when migrating to ZMatter Z-Wave+
• ZWAY.LOG was not properly archived
• Fixed the "Write Changes" button 

Next

• More bug fixes, and unless higher priority issues crop up, better support for detecting events from button presses, motion sensors etc.