vbPhil Posted January 11, 2023 Share Posted January 11, 2023 I'm thinking of using the Aeotec Heavy Duty Smart Switch Gen5 (ZW078) to control my garage heater. Was curious about the function it has to report wattage or kWH. I'm not sure where UDU publishes what z-wave command classes it's supports. Would this be supported by Polisy with the ZMatter board and display these parameters in the AC? Quote Your Heavy Duty Smart Switch can report Watts energy usage or kWh energy usage to a Z-Wave gateway or controller. If this function is supported by the gateway/controller, your energy consumption will be displayed within its user interface. The specific Z-Wave commands supporting energy monitoring are the Meter Command Class and Multilevel Sensor Command Class. Automatic reports go to association group 1, which is set up via the Association Command Class. Please consult your gateway/controller manual for instructions on monitoring energy consumption through your Heavy Duty Smart Switch. Link to comment
Techman Posted January 11, 2023 Share Posted January 11, 2023 (edited) The Aeotec ZW078 is compatible with the ISY Here's their compatibility list https://aeotec.com/compatibility/ Note: the compatibility list contains devices and Hubs that Aeotec has tested and deemed compatible. They don't show the Polisy or eisy yet, but if they work with the ISY994 then they most likely will work with the Polisy and eisy. Edited January 11, 2023 by Techman Link to comment
Recommended Posts