hart2hart Posted January 19 Posted January 19 (edited) I just installed and discovered two ratgdos on Chamberlin Security 2.0+ doors. I can control both doors and lights. However, I was very surprised that I didn't have to learn the ratgdo as a controller in the rolling code scheme -- they just worked first try. How did this happen? The value of Obstruction is "Clear" for one door and "Unknown" for other door after multiple open/close cycles. Does this mean I've not got good contact on the black sensor wire? Edited January 19 by hart2hart
hart2hart Posted January 20 Author Posted January 20 @Goose66 After some amount time the Garage Door Opener Door State and Lockout Status are becoming Unknown. The Light Module Status is doing the same.
Goose66 Posted January 20 Posted January 20 But… thinking about this, when it comes online it won’t repost its state values (the ratgdo uses retained messages) and there is no periodic query of state, so if it does go offline and the states are set to unknown, they will remain unknown until they change (assuming the ratgdo is back online when the change occurs).
hart2hart Posted January 20 Author Posted January 20 Should only happen if the ratgdo devices go offline.Thanks. Do you think they’re going offline as in WiFi dropped or power lost? Suggestion on how can I monitor?
hart2hart Posted January 20 Author Posted January 20 I opened and closed both doors. Doors listed as Closed and Lights On then Off. Less than 20 minutes later, all status are Unknown.
hart2hart Posted January 20 Author Posted January 20 (edited) @Goose66 It was my garage based access point rebooting. Edited January 20 by hart2hart
Goose66 Posted January 20 Posted January 20 That makes sense. I’ll have to think about how we should be handling that, but I will log a change for the next version. 1
Recommended Posts