Added Aeotec Zigbee Motion Sensor but it doesn't do anything.

[philgood]

After adding the Aeotec Zigbee Motion Sensor (‎GP-AEOMSSUS) and seeing the screen with all the items listed (Intrusion, Presence, Tamper, Low Battery, Reports Supervision, Reports Restore, Trouble, AC/Mains Fault, Test and Battery Defect), I find that it dosen't do anything like sense motion.  I would expect that not only would I see one of the listed items change indicating that motion was detected but that the LED on the motion sensor would light up but... nothing. According to the included manual, after adding the Motion Sensor you should see a Motion and Temperature field but neither of those show.

I even wrote a small program to test it but non of the items (Intrusion, Presence Tamper...) cause any changes.

What am I not understanding?

Also, my system was working fine but after adding the motion sensor, the first time, the system locked up and after doing a reset the ISY FInder no longer was able to find the Polisy.  A factory reset had to be done and the system restored.  This happened twice, so I have a feeling it might be related.

Edited April 16 by philgood
Added additional information