Jump to content

Question about Node Def mapping to admin console for Alarm Panel


Go to solution Solved by gzahar,

Recommended Posts

Posted (edited)

Hi @Goose66,

I am wanting to add name substitutions for the various panel status values for notifications but I have not been able to locate what the various node definitions map to in the admin console. 

For instance, GVO sends its value to what slot in the admin console on the Alarm Panel page?

I have figured out that ST maps to System Alarm State but I could use all the rest.

Any help would be appreciated.

Thank you,

Tim

Capture.JPG

 

 

Capture2.JPG

Edited by TJF1960
Link to comment
  • Solution

ST-ACP-ST-NAME = Alarm Panel Connected

ST-ACP-GV0-NAME = System Alarm State

ST-ACP-GV4-NAME = Bell Trouble
ST-ACP-GV5-NAME = Battery Trouble
ST-ACP-GV6-NAME = AC Trouble
ST-ACP-GV7-NAME = FTC Trouble
ST-ACP-GV8-NAME = Tamper Trouble
ST-ACP-GV9-NAME = Fire Trouble
ST-ACP-GV10-NAME = Zone Fault
ST-ACP-GV11-NAME = Zone Sensor Low Battery

  • Thanks 1
Link to comment

The owner of the plugin has the PG2 version of the code on GitHub. The mappings didn’t change when it was converted to PG3. Also, I believe the A/C normally shows these starting with ST then GVx in numerical order, but there may be exceptions.

  • Like 1
Link to comment
Guest
This topic is now closed to further replies.

×
×
  • Create New...