Has anyone replaced the battery on the Remotelinc2?

I have seen a post on the former owners forum. Of someone doing that. I believe it was finding a battery close enough in size and some reported the case snaps where glued in later revisions. My statement was not completely correct on not realizing the battery had built in protection.

From the FCC Database web site.

Battery.pdf23422ip.pdf

Edited July 27, 20241 yr by Brian H
Found Internal photos.

Thank you

You are welcome.

Hope it helps and I am glad the FCC Database had the internal photos.

The battery pack is a custom-made unit with internal protection using a commonly-made Seiko chip.  This is pretty common for Li-Po flat-pack batteries.

Here are the specs:

Battery, Lithium,  46.5 x 25.5 x 3.2mm,   3.7V,    300mAh

Most units made in the last five years the milliAmp capacity was bumped up to 320mAh.

The battery charge rate is set by an IC on the Mini Remote PCB.   I expect that if you can find something that fits, even if it is smaller, go for it.  Also, Mini Remotes that are revision 1.8 or later have many other improvements to decrease the standby current and increase the battery life between recharges.

-Pinch