Comm Errors popups can't be cleared during network query

[yardman 49]

Hello Michel:

 

I noticed after installing 2.6 that I can't "clear" a comm error warning pop-up during a all-network query until all the devices have been queried.

 

Up until now, I could click on "OK" to each devie Comm Error as the query was still underway. But now the GUI forces me to wait until the entire network query has completed prior to clearing any Comm Errors by clicking on "OK".

 

Is this a "bug" or a "feature"?

 

 

Also, I notice another issue that has been there all along: sometimes a Comm Error pops up during a network query, but later when I look in "My Lighting", there is no error being reported for that device (no red exclamation mark). And when I requery the device, it responds with no errors.

 

 

Best wishes,

[Guest]

Hello Michel:

 

I noticed after installing 2.6 that I can't "clear" a comm error warning pop-up during a all-network query until all the devices have been queried.

 

Up until now, I could click on "OK" to each devie Comm Error as the query was still underway. But now the GUI forces me to wait until the entire network query has completed prior to clearing any Comm Errors by clicking on "OK".

 

Is this a "bug" or a "feature"?

 

 

Also, I notice another issue that has been there all along: sometimes a Comm Error pops up during a network query, but later when I look in "My Lighting", there is no error being reported for that device (no red exclamation mark). And when I requery the device, it responds with no errors.

 

 

Best wishes,

 

Same things were happening here. I thought it was poor communications between the PLM and the switches.