apostolakisl Posted December 6, 2011 Share Posted December 6, 2011 I was wondering if you might consider supporting the "type 4" zone setting. You can have 1) not secure - open 2) not secure - short 3) not secure with resistor 4) secure with resistor Link to comment Share on other sites More sharing options...
Chris Jahn Posted December 7, 2011 Share Posted December 7, 2011 I was wondering if you might consider supporting the "type 4" zone setting. You can have 1) not secure - open 2) not secure - short 3) not secure with resistor 4) secure with resistor I wondering if its just a terminology thing as there are 4 physical options to choose from currently. The is something the Elk guru's could possibly help with. Link to comment Share on other sites More sharing options...
apostolakisl Posted December 7, 2011 Author Share Posted December 7, 2011 I was wondering if you might consider supporting the "type 4" zone setting. You can have 1) not secure - open 2) not secure - short 3) not secure with resistor 4) secure with resistor I wondering if its just a terminology thing as there are 4 physical options to choose from currently. The is something the Elk guru's could possibly help with. I am only showing 3 usable physical status choices on ISY. "Not configured" doesn't make any sense to me since there is no way to have a zone on Elk with configuration blank. The more advanced way to set up an Elk zone is to have an EOL resistor in place for both secure and not-secure. In this mode, "not secure" is one voltage, "secure" is another voltage, and "open/short" are both trouble. I have a zone setup this way and would like ISY to be able to tell the difference between "open" trouble and "short" trouble. Perhaps I can do a work around where I have it querry the voltage any time it reads "trouble" and then use the voltage ranges to control my programs. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.