windrockwater Posted February 21, 2012 Posted February 21, 2012 So I seem to be really missing the "link" with regards to getting a program to work with an insteon motion sensor for room occupancy (bad pun intended). Can anyone give me some tips as to what jumpers to set on the motion sensor AND what options for the motion sensor to set in ISY (Night Mode, Sensor Mode, etc. none of this stuff is in wiki)? I am trying to setup a basic room occupancy program for my bathroom (for testing really). There are two lights (ceiling light and mirror lights). I am trying to create a program like this: If the motion sensor senses motion AND both lights are currently OFF (or not ON I guess) AND it is nighttime THEN set mirror light to 50% THEN turn off BOTH lights about 1 minute after a person leaves the room (or the motion sensor stops sensing motion) Seems so simple but I am struggling! I had a hard time in Logic....
LeeG Posted February 21, 2012 Posted February 21, 2012 Take a look at this topic. It should cover much of what you are looking for, viewtopic.php?f=25&t=5184
Recommended Posts