ergodic Posted May 29, 2012 Posted May 29, 2012 So I'm trying to test out an inlinelinc w/ sense connected to my ISY (f/w 3.1.17). The device is labeled as a 2475S2. I'm able to add it to the ISY as a manual link device using the "B2475S - In-linelinc relay W/ sense". But once in there it just shows in the "on" state. I don't have a load connected yet, does it require one? Even when I push the on/off buttons manually, it still always shows "on" in the ISY and I see no comm traffic. Tying the yellow sense line to hot or ground makes no difference either. I'm starting to think I don't understand how this device is supposed to work.
LeeG Posted May 29, 2012 Posted May 29, 2012 I suggest moving to 3.2.6, Delete the InLineLinc w/sense and add it back with Auto Discover under 3.2.6. It is a Relay device and SmartLabs has been updating Relay based devices to I2CS first. You can try a Show Device Links Table for the InLineLinc which will not be correct if it is an I2CS device.
ergodic Posted May 30, 2012 Author Posted May 30, 2012 Thanks Lee. Made a huge difference. Haven't done anything much with it yet, but it all seems now to be working the way I would expect under 3.2.6
Recommended Posts