I use a pfSense router with Acme Certificates (letsencrypt), and HAProxy. I use to access things like Home Assistant, OpenSprinkler remotely, but can also be used locally with the FQDN... also setup Dynamic DNS via GoDaddy. I never had issue connecting to local IP address of PG3, but I rarely do and do not see a reason why I would need to connect to it often anyways - it's sort of set and forget and not really much to look at in there.
Are these errors you are getting preventing you from accessing the site, or is it just an insecure site warning that you can click through?
No, it should be left slot. Probably doesn't matter though really but I would put it in left as per instructions. I don't think there will be a process release to migrate until 12/01/2022 as per email.
We are very excited to let you know that we received the ZMatter modules in full, and sample testing has been completed. While we put the final touches on the IoX (ISY on Anything) – especially backup/restore – we decided to start shipping out the orders by tomorrow (11/23).
Preparations:
1. If your Polisy has been collecting dust for more than a year, the first thing you need to do is to freshen it up. Here’s how you do it. Once done, you can access your Polisy just like you did your ISY994. Here’s how to do so.
2. If you have not already migrated your ISY994 to Polisy, that’s the first thing you need to do. Migration is easy and you can even use your existing PLM for INSTEON/X10 communications. Here are the instructions.
3. You will be sent further instructions for the required IoX version and how-tos for untapping our additional features and enhancements by 12/01/2022.
Installation Instructions:
1. Unplug Polisy from power
2. Take off the top panel by unscrewing the 4 screws on the sides (2 on each side)
3. Connect the SMA side of the antenna wires into the two holes on each side of the top panel
4. Plugin the ZMatter board into the first mPCIe slot from the left. Ensure that it latches in just like the SSD. Please note, you may not have a WiFI card.
5. Align the top panel on top of Polisy and move it backward so that you can see the u.FL connectors on the board.
6. Gently push in the u.FL side of the antenna wires into the u.FL connectors. Ensure that they click in
7. Gently push the top panel back so that it’s flush with the bottom and screw back the 4 screws on the sides
8. Attach the antennas one on each side.
NOTE: facing the front of the unit
· Z-Wave antenna has a Yellow band on top and goes to the left
· Zigbee antenna has a Red band on top and goes to the right
Enjoy the beauty!
With Kind regards,
*************************************************
UD Sales
Store: https://www.universal-devices.com/store
Information (Wiki): https://wiki.universal-devices.com
Information (Forum): https://forum.universal-devices.com
Like us on Facebook Follow us on Twitter
