mr4js

Would be nice if the I/O Linc was Dual Band. Perhaps then it could be on the UPS and send via RF.

My PLM is near a Surge Suppressor, but not connected directly to it. I have the ISY-99i/IR, so it is near my entertainment center because I plan to use my Harmony remote with it. All of my Entertainment center equipment is connected to a surge suppressor. I do have a SmartHome X10 repeater and I think my phases are coupled, but not sure how to prove it. Most X10 commands reach the intended destinations, but some get lost no matter what I try. X10 commands sent from my ISY always reach the intended destination OK, but not the other way around. I am gradually phasing out X10, but I have some modules that I really like. I updated some X10 lamp modules with a Solid State Relay so they are 100% silent and work great with CFl's and LED's and they are really fast. I also like the X10 Rocket socket lamp socket because it is silent. Having all X10 commands go through my ISY is nice because it keeps track of the ON/Off status, but reaching it from all locations in my house is the puzzle I need to figure out now.

Set up an X10 Transceiver closer to my PLM and I am receiving X10 commands now.

Set up an X10 Transceiver closer to my PLM and I am receiving X10 commands now.

Lee, The Event Viewer stays blank when I send an X10 command from my Keypad. The actual X10 device does respond from Keypad commands. The commands only show in the Event Viewer when the ISY sends them. Thanks, John

I have the ISY-99i/IR with the X-10 module installed and R2.8.10. I can send X10 commands via the ISY OK, but the ISY will not recognize X10 commands sent to it from an X10 Keypad. My X10 modules will activate via the keypad OK, but the ISY does not recognize the X10 transmissions from the Keypad. I have an ISY program to monitor X-10 D4 Status If X10 'D4/On (3)' is Received And X10 'D4/Off (11)' is not Received Then - No Actions - (To add one, press 'Action') Else - No Actions - (To add one, press 'Action') But the status does not change when I send a D4 from my keypad. If I send a D4 from the ISY, the status does change. How do I get incoming X10 commands to be recognized?