delboy

That brings up the old admin interface but if you change the "admin user". it reverts back to portal user next time! (running v6.0.0.)

sorry in your case "is not switched off"

Oh I seem to remember that the conditions are reevaluated after a wait, so add a "is not switched on" to the condition. Also I'm surprised on the lack of support from UD on z-wave. The only reason I bought an EISY for migration away from Insteon.

Many thanks I did read the thread on z-wave associations. What a mess I thought z-wave was the way of the future alas even X10 had the scene concept built in and Insteon is arguable an equivalent transmission protocol. I have tried one Zigbee - it affects wifi on 5Mhz. I now have the button working.

Many thanks I did do the above and got "switch", "keep alive", scenes 1-4 and associate groups 2-9. But now what? Do I just program the scenes "on" to do stuff, or do I add to scenes? I can not see where I perform a z-wave association. I also have a Aeotec wallmote/quad. That interviews without apparent problems, but again, what now? Insteon was a lot easier!

Has anyone successfully used a M800S 4 button remote switch with Z-matter (Eisy 5.8). If I reset it I can sort of get through the interview and get 10 nodes, a switch, a keep alive and Association 2 to 9. None of these nodes have any status, sending a query make the admin console hang in "red busy". if I add them to a scene there are no links boxes. I can get button events "basic set" when I turn that on but can not make a program action on anything. If I "update with interview" I lose all but two nodes. Is there a better button device for zwave (the m800s is cheap) I'm new to zwave, I used to have ~50 Insteon device, replacing them with zwave now, slowly.