hart2hart
Members
-
Joined
-
Last visited
Solutions
-
hart2hart's post in ISY backup fails was marked as the answerCould this mean the SD card has gone bad and you should replace it before doing the restore?
-
hart2hart's post in Nodes not controlling Fans and Lights today was marked as the answer@Goose66I realized that PLM was not registering the insteon device update so I did a restore PLM and all is working now -- sorry to have bothered you with it. Of course the PLM may need a replacement soon. I'll watch it. I prophylactically replaced the capacitators a couple years ago.
-
hart2hart's post in Moved all node servers to PG3 - now what? was marked as the answerAre you running all on a Polisy? If so, PG2 will use almost no resources without node servers. Also, it’s been mentioned that pg2 will be removed from Polisy by UD sometime in the future
-
hart2hart's post in Going back to INSTEON was marked as the answerThose are probably addresses that existed in that switch. When you add there are question about finding them. If that’s your older switches, I’d factory reset each before linking them. I’d delete that one and add again.
-
hart2hart's post in ISY died, need replacement was marked as the answerMaybe SD card was damaged when power supply failed. Replace it and restore a backup might be a possibility. Also, just saw post where a rj45 cable went bad and caused issues.
-
hart2hart's post in Toggle the button state of an Insteon 2487S 6-button switch with a program was marked as the answerAdd the button to a scene (create scene if needed) and turn the scene on and off.