luken001 Posted December 14, 2013 Posted December 14, 2013 My PLM died (no green light). I bought a new one and did the PLM restore step. The ISY994i can talked to the devices and the programs work; however, device status changes are no longer being reflected in the ISY or event viewer. If I do a query, it finds the new status. Also, when re-linking, it used to go through a series of "writing" steps that were shown on the admin console. This no longer happens. Any thoughts?
LeeG Posted December 15, 2013 Posted December 15, 2013 NO, do not run Delete Modem! Run Show PLM Links Table and click Count when display is finished. May be necessary to do this a few times to insure the count is consistent.
luken001 Posted December 15, 2013 Author Posted December 15, 2013 Ran it several times and it settled on "15" - there are 24 items listed under ISY (1 sensor/relay and one 6-button unit)
LeeG Posted December 15, 2013 Posted December 15, 2013 First run Tools | Diagnostics | Show PLM/Info. Verify it is showing the correct PLM info. There is one Sensor/Relay and 1 6 button KPL installed? Is that all the Insteon devices?
luken001 Posted December 15, 2013 Author Posted December 15, 2013 The other devices are switches and plugin controls. I was able to get the sensor/relay working by deleting the device and re-linking.
Recommended Posts
Archived
This topic is now archived and is closed to further replies.