I/O Link 2450 and 2475SDB programming

[dgmorr]

Hey guys,

 

I have a failry simple Insteon setup so far and this will be my most 'complex' setup which I'm having some trouble with. I am using an ISY 994i with a 2475SDB and I/O Link 2450 for this circuit.

 

I am basically trying to control my pool pump and millivolt pool heater. I have the 2475SDB wired in to the pool pump and have that working no problem. What I am trying to do is have the I/O Link 2450 control my pool heater's fireman switch (basically an open/close, no voltage). How do I link these two devices so that in any circumstance, the pool heater must be shut off 20 minutes prior to the pool pump shutting down. I'm a little lost on how to begin.

 

My pump is 120V 20A if there was any question about that.

 

Thanks.

[SteveL]

djmoor,

 

The basic concept of what you are trying to do seems to be something like this.

 

If: Control of "Choose your Control" is Off

 

Then: Turn off Heater I/O Linc

then wait 20 min

then turn off pool pump

 

Please email me at support@universal-devices.com if you need further assistance.