tdotr6 Posted May 28, 2014 Share Posted May 28, 2014 Hello, I know I have searched around and the question has been asked and I just recently updated my ISY firmware and I see that the morninglinc status does work correctly, when the door is locked and unlocked the correct status is shown... http://i.imgur.com/qxeKQr0.png , yet when I go to set a program there is no status to choose from..http://i.imgur.com/yJIvYa6.png am I doing something wrong or is status of morninglinc devices still not supported? Link to comment
PurdueGuy Posted May 28, 2014 Share Posted May 28, 2014 MorningLinc devices are one way. The ISY can command a lock or unlock, but it won't know of the command was received and processed. ISY also won't know when the lock is operated manually via key or internal latch. From this page: http://www.smarthome.com/2458A1/Morning ... ler/p.aspx Important Note Regarding Lock Status: The MorningLinc converts INSTEON commands to Morning Industry's RF commands. Since this RF is one-way, an INSTEON system cannot confirm whether the lock has received the RF command or not. Please exercise your best judgment when remotely controlling or automating door locks. Link to comment
v101 Posted August 6, 2014 Share Posted August 6, 2014 wondering if any updates have been made to this? is full support for this on the way? or has anyone discovered any work arounds? to the morning industry locks w/ the ISY 99? Link to comment
LeeG Posted August 6, 2014 Share Posted August 6, 2014 The limitations are based on the design of the lock set. There have been no changes and none are expected. Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.