isyrocks! Posted July 20, 2014 Posted July 20, 2014 Yesterday morning my ISY started behaving very erratically. When I use a Insteon light switch/keypadlinc/Insteon remote and perform an action the corresponding programs are not running. Timed Programs are working just fine. If I look under the Programs > Status tab they don't show up as trying to run I can execute the Programs manually from the ISY console and they work fine The only fix I have found is to restore the Insteon device. Right now I am debating whether I need to go through each device one by one and restore it. After the device is restored the Programs run properly. I am loosing my mind trying to figure out what happened. I have not made any changes in the last few days. I was running firmware 4.2.3. I just upgraded to 4.2.5 (RC) to see if that would help. Unfortunately same situation. I put in a ticket for support and am waiting to hear back. Any ideas how I can fix whatever is happening?
LeeG Posted July 20, 2014 Posted July 20, 2014 Try File | Restore Modem (PLM) rather than restoring each device.
isyrocks! Posted July 20, 2014 Author Posted July 20, 2014 LeeG thanks for the quick reply. Restoring PLM now. Fingers crossed.
isyrocks! Posted July 20, 2014 Author Posted July 20, 2014 I think my issues are now resolved after the PLM restore. Need to keep an eye on it the next few days. Thanks again LeeG.
Recommended Posts
Archived
This topic is now archived and is closed to further replies.