calberrt Posted December 29, 2014 Posted December 29, 2014 Hi Guys, Last night was the first night with the new t2441 installed so I'm looking for some help on working out the kinks. I have written a few programs that set the heating point to different temps throughout the day. I noticed last night when I got up that the set point noted on the thermostat didnt change.(ie. Set point throughout the day is 72 and wanted it to go down to 65 at night) Here are my programs. Hopefully someone with a bit more experience can take a look and help me out to make sure that I have written them correctly. Evening program (want it to run between 4:15 and 9pm If From 4:15:01PM To 9:00:00PM (same day) And Status 'Thermostat - Main' is Mode Heat Then Set 'Thermostat - Main' 72° (Heat Setpoint) Else - No Actions - (To add one, press 'Action') Night Program If From 9:00:01PM To 4:44:59AM (next day) And Status 'Thermostat - Main' is Mode Heat Then Set 'Thermostat - Main' 65° (Heat Setpoint) Else - No Actions - (To add one, press 'Action') I think that temp throughout the house stayed at 72 overnight when I wanted it to be at 65. Any advice guys? Also, should I expect that the ISY will automatically send a signal to the thermostat that will update the setpoint while the program is active or do I have to write a program to deal with this?
calberrt Posted December 29, 2014 Author Posted December 29, 2014 I think I figured it out. It had to do with my conversion from fahrenheit to celsius. It seems to be working now!
Recommended Posts