osurh18 Posted September 30, 2015 Posted September 30, 2015 I've added both my switch and outlet to a scene called Room Lamp. I have set the switch to be the controller and the outlet to be the responder. However when I turn the switch on or off nothing happens with the outlet. Please help. Thanks.
stusviews Posted September 30, 2015 Posted September 30, 2015 Which outlet? What's plugged into the outlet?
osurh18 Posted September 30, 2015 Author Posted September 30, 2015 It's an outletlinc that has a lamp plugged into it
stusviews Posted September 30, 2015 Posted September 30, 2015 There are three OutletLincs with different requirements. Which one do you have? What kind of bulb is in the lamp? Did you turn the lamp and verify that it is on before plugging it into the OutletLinc?
osurh18 Posted October 1, 2015 Author Posted October 1, 2015 Sorry didnt realize there were multiple versions. It is a 2473. It has a lamp plugged into it. The lamp does turn on and off with pressing the button on the outletlinc. The only way I've been able to get the switchlinc to be able to control it is by using a program If Switch is On then Set Outlet On else Set Outlet Off Is this the only way to do it?
stusviews Posted October 1, 2015 Posted October 1, 2015 (edited) No, you should be able to control the On/Off Outlet using a scene. Click on the scene. Ensure that both the Outlet and the SwitchLinc are set to 100%. Select Tools > Diagnostics > Event Viewer. Set the level to 3 Device communications events. Right click on the scene and select Diagnostics > Scene test. Did the test succeed? Edited October 1, 2015 by stusviews
osurh18 Posted October 1, 2015 Author Posted October 1, 2015 Thanks for the help. Not sure what happened, but when I went through the steps you described the test came back successful and the switch worked from then on. Thanks again
Recommended Posts