BamBamF16 Posted November 10, 2015 Share Posted November 10, 2015 This issue has always been present. I am just now seeing if I can fix it. When I get a notification via isy every one comes from a different but sequential number. I send my messages through Gmail's smtp server. They are routed through mynumber@att.net (forget the exact address but it is the default for AT&T test message via email). Is there a way to make the come from the same number so they group as a conversation? I am also looking for the correct parameter to get the temperature from a ZWave mti sensor? ST does not work. I can get the valid name and address but not formatted parameter value. Thanks Jeff Link to comment
MWareman Posted November 10, 2015 Share Posted November 10, 2015 This issue has always been present. I am just now seeing if I can fix it. When I get a notification via isy every one comes from a different but sequential number. I send my messages through Gmail's smtp server. They are routed through mynumber@att.net (forget the exact address but it is the default for AT&T test message via email). Is there a way to make the come from the same number so they group as a conversation? That's a question you'd have to ask AT&T. As far as I'm aware, this is standard for their email-to-sms service. I've had success using the network module to send SMS via Twilio, but its not a free service. You might be able to use IFTTT to forward emails to SMS and have a consistent number as well. Link to comment
jerlands Posted November 10, 2015 Share Posted November 10, 2015 You can try yournumber@mms.att.net but I understand there are occasional delays. Jon... Link to comment
BamBamF16 Posted November 10, 2015 Author Share Posted November 10, 2015 Thanks guys. I'll try that. Any idea on the parameter I might use to get temp from the ZWave MS? Link to comment
Scott847 Posted November 11, 2015 Share Posted November 11, 2015 Thanks guys. I'll try that. Any idea on the parameter I might use to get temp from the ZWave MS? My Aeotec MultiSensor 6 is currently Z-Wave device #17. Following are the formatted and raw output for temperature: ${sys.node.ZW017_1.CLITEMP} returns "70.80° F" ${sys.node.ZW017_1.CLITEMP.raw} returns "70.80" One way to find codes such as CLITEMP is to look in the ISY Event Viewer. These codes show up each time Z-Wave devices report in. Link to comment
BamBamF16 Posted November 12, 2015 Author Share Posted November 12, 2015 Thanks for that tip! It is indeed CLITEMP for this one as well. Jeff Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.