universe Posted March 4, 2016 Posted March 4, 2016 I've been looking on the site for a place that explains the event viewer entries in detail for X10 devices. I am trying to use event viewer to figure out where particular commands are coming from. I'm assuming the 4 pairs of numbers are device identifiers. I also see entries with X10-RSP and X10-RX. Is there a best thread in the forum that explains using event viewer to debug X10 problems? Thanks.
LeeG Posted March 4, 2016 Posted March 4, 2016 (edited) Can't tell much from X10 messages as far as which device produced the traffic. Don't think you will find much that helps identify which device. The traffic below came from an X10 Pro Maxi Controller. X10 traffic is in 2 parts .... 02 52 59 00 02 52 = PLM identifier for X10 message 59 = 5 is G; 9 is 6 00 = first part of X10 message - contains House/Unit code 02 52 52 80 02 52 = PLM identifier for X10 message 52 = 5 is G; 2 is On command 80 = command message - contains House/X10 Command Fri 03/04/2016 12:09:26 AM : [X10-RX ] 02 52 59 00 Fri 03/04/2016 12:09:26 AM : [ X10] G6 Fri 03/04/2016 12:09:28 AM : [X10-RX ] 02 52 52 80 Fri 03/04/2016 12:09:28 AM : [ X10] G6/On (3) Fri 03/04/2016 12:09:29 AM : [X10-RX ] 02 52 59 00 Fri 03/04/2016 12:09:29 AM : [ X10] G6 Fri 03/04/2016 12:10:41 AM : [X10-RX ] 02 52 59 00 Fri 03/04/2016 12:10:41 AM : [ X10] G6 Fri 03/04/2016 12:10:43 AM : [X10-RX ] 02 52 53 80 Fri 03/04/2016 12:10:43 AM : [ X10] G6/Off (11) Fri 03/04/2016 12:10:44 AM : [X10-RX ] 02 52 59 00 Fri 03/04/2016 12:10:44 AM : [ X10] G6 Google the Internet for X10 House/Unit/Command charts. A PLM Guide also has X10 charts. Edited March 4, 2016 by LeeG
Brian H Posted March 4, 2016 Posted March 4, 2016 (edited) PLM Developers Guide: Pages 26-27 are X10 related. http://cache.insteon.com/developer/2413dev-042007-en.pdf http://cache.insteon.com/developer/developer-guide-022009-en.pdf Edited March 4, 2016 by Brian H
Recommended Posts