replaced capacitors in PLM now motion sensors sometimes flash

[neutron7]

I did the re cap on my failed PLM, which fixed it, but since then all 3 of my motion sensors will occasionally flash for a bit after being triggered, and can not be retriggered during that time. all of them were very reliable before the PLM failed. is there something else i can do in the ISY to test or fix it, or should i just go ahead and get a new one?

 

all the sensors are quite close to dual band devices, and i have about 10 dual band devices in my house. ISY994ir

[Techman]

I did the re cap on my failed PLM, which fixed it, but since then all 3 of my motion sensors will occasionally flash for a bit after being triggered, and can not be retriggered during that time. all of them were very reliable before the PLM failed. is there something else i can do in the ISY to test or fix it, or should i just go ahead and get a new one?

 

all the sensors are quite close to dual band devices, and i have about 10 dual band devices in my house. ISY994ir

Try putting the sensors into linking mode, only one at a time, then do a restore device. It's possible some of your PLM link records got corrupted.

Be sure that the link mode has stopped before putting the next sensor into linking mode

[neutron7]

thanks, i have done that, ill see how it goes.

[neutron7]

just thought I should post an update. it has Been a few days since I did this, and have not seen the flashing once. thanks again!